Ducati Scrambler 800 - Service manual > Refitting the rear-view mirrors

Position the RH mirror (2) with nut (1) on the U-bolt.

Screw the RH rear-view mirror (2) in the indicated direction until reaching the required position.

Then, keeping the rear-view mirror in its position, tighten nut (2), always in the indicated direction, to a torque of 25 Nm +- 10 %.

Removing the rear-view mirrors

Loosen nut (1) in the direction shown in the figure.

Loosen the rear-view mirror (2).

Follow the same procedure with the LH mirror.

Seat - tail guard - side body panels

Refitting the tail guard (CLASSIC)

Check that clips (7) are fitted on mudguard support frame (5).

Fix the two turn indicators (8) with screws (9).

Position splash guard (10) on frame (5) and fix it with screws (11).

Fit cat's eye (12) and fix it with two nuts (14) with washer (13).

Position number plate light (16) by inserting cable (15) in frame (5) as shown in the figure.

Fix the number plate light (16) by means of screws (17).

Position the wiring with ties as shown in the figure.

Fit mudguard (3) and fix it with screw (6).

Position the rear subframe/mudguard assembly on the vehicle.

Start screws (4).

Working on the lower side, start screws (1) and (2).

Tighten screws (4), (1) and (2).

Connect the turn indicator and number plate light connectors.

Removing the tail guard (CLASSIC)

Disconnect the turn indicator and rear number plate connectors.

Remove screws (1) and (2) located on the lower side of the rear mudguard (3).

Remove screws (4) that retain the rear mudguard (3) on both sides of the vehicle.

Remove the frame/mudguard assembly.

Remove screw (6) to remove the rear mudguard (3) from its frame (5).

See also: