Royal Enfield Bullet Trials Works Replica - Owner's Manual > Parking
PARKING MOTORCYCLE ON CENTER STAND
- Select a firm, flat surface.
- Hold handle bar straight.
- Lower center stand, such that, both the legs of the stand are resting on firm ground.
- Apply pressure on the fulcrum lever on the center stand and pull motorcycle backward.
PARKING MOTORCYCLE ON SIDE STAND
- Select a firm, flat surface.
- Extend side stand. Tilt the motorcycle to the left, till it is supported
firmly.
C A U T I O N
When Side stand is in extended position.
- Engine will start if vehicle is in neutral, but will cut-off (ignition and fuel) when gear is engaged.
- Engine will not start if gear is engaged already.
W A R N I N G
Ensure both the stands are retracted fully before riding the motorcycle.
Please exercise extreme care while parking and ensure it is parked firmly to avoid the motorcycle from falling over and causing injury to you or to others and damage to the motorcycle parts.
Periodical Maintenance
The maintenance schedule detailed here will help you maintain your Bullet 500 Trials Motorcycle meticulously and to get a long trouble free service. The schedule provided herein is based upon average riding conditions and indicates the Kms at which regular inspections, adjustments, replacements and lubrications are to be carried out. The frequency of the maintenance must be shortened depending upon the severity of the driving condition or if the motorcycle is used in a very dusty environment. Contact the nearest Royal Enfield Authorised Dealer / Service Center for expert advice and to carry out the required maintenance.
A : Adjust
C : Clean
D : De-carbonise
I : Inspect
L : Lubricate
R : Replace
NOTE For Maintenance after 30,000 Kms, Please repeat the same frequency specified above, in consultation with a Royal Enfield Authorised Dealer / Service Center.
Tools kit
The tool kit is located in the left side Electrical box of the motorcycle.
- Tool bag
- Box spanner 21 X 24
- Screw driver O6 X 160
- Double end spanner 14 X 15
- Double end spanner 10 X 12
- Tool- Spark plug
- Tommy bar
- Tubular spanner 12 X 13
- Single end ring spanner - 17
- Extension tube
* Please familiarise yourself with the minor maintenance of the motorcycle before attempting to carry out the same.
See also:
Royal Enfield Bullet Trials Works Replica - Owner's Manual > Gear Shifting, Riding & Stopping
NOTE Release the Starter button as soon as the Engine starts. If Engine does not start, wait for 30 seconds before pressing the starter switch. A Clutch switch is provided in the system for the safety of the rider. When the motorcycle is in gear, the motorcycle cannot be started. To start in gear depress the clutch lever and press Starter button to start engine. Warm up engine for 2 minutes. Depress clutch lever. Press gear pedal with toe to engage 1st gear. Gently open throttle and release clutch lever simultaneously. If clutch is released suddenly, the engine may stall and cause the motorcycle to move with a jerk. To shift to 2nd and higher gears close throttle, depress clutch lever and press the gear pedal with heel.
Ducati Scrambler
Fantic Caballero 500
Indian FTR 1200
Moto Guzzi V85 TT
Royal Enfield Bullet Trials Works Replica
Triumph Scrambler 1200 XE
Triumph Street Scrambler
Yamaha XSR700
Ducati Scrambler 800
Moto Guzzi V85 TT
Triumph Scrambler 1200 XC