Royal Enfield Bullet Trials Works Replica - Owner's Manual > Washing Procedure

PRECAUTIONS

• Wash motorcycle when the engine is cold.
• Cover the silencer, tail pipe, carburetor, horn and control switches with suitable plastic bags and tie it firmly to prevent water entry.
• Remove ignition key and seal key hole using adhesive tape.
• Brush engine area with a solvent to remove dirt or grease.
• Use low pressure jet of water to clean.
• Never spray water with great force on head lamp, speedometer, flasher lights, front and rear wheel hubs, electrical connections and wires, control cables, carburetor, spark plug, battery etc.
• Do not apply any corrosive solvent on painted surfaces or rubber parts.
• Use luke warm water and mild detergent on the painted components to remove dirt, etc.
• Rinse motorcycle thoroughly with plain water to remove the detergent.
• If possible, use compressed air and blow off water particles from the obscure areas of the motorcycle, electrical connections etc.
• Once the motorcycle has been ridden in salty conditions or near coastal areas it is recommended to wash your motorcycle with cold water. Please do not use warm water for washing as it may damage the motorcycle due to chemical reaction with the salt. After washing process once the motorcycle is completely dry it is recommended to apply anti corrosion spray on all the metal and chrome plated areas to protect the parts from corrosion.
• It is recommended not to apply the anti-corrosion spray on the brake discs.

AFTER WASHING

• Ensure, the motorcycle is thoroughly dry by wiping with a clean soft absorbent cloth or chamois leather.
• Remove all plastic bags and adhesive tapes.
• Lubricate control cables, pivot and rear chain with lube oil.
• Start engine and allow to run at idling speed for a few minutes to warm up engine.
• Drive the motorcycle slowly, applying both brakes intermittently to dry up the water in the brake shoes.

Storage Precautions

Incase your Motorcycle is not going to be used for a month or more, the following precautions should be taken.

• Get the motorcycle service through a Royal Enfield Authorised Dealer / Service Center.
• Drain fuel tank and fuel line.
• Keep the fuel tap in closed position and spray engine oil inside the fuel tank to prevent rusting.
• Remove spark plug. Pour in about 25ml of clean engine oil through spark plug hole. Close the hole and crank engine several times and refit spark plug.
• Clean rear chain thoroughly and apply a thin film of lub oil.
• Remove battery from the motorcycle. Clean the terminals free of corrosion and apply petroleum jelly to terminals.
• If the motorcycle is not used for a month or longer, It is advised to disconnect battery terminals and remove the battery. Before refitting the battery in the motorcycle, check the battery voltage is within specification, if not, recharge it from authorized service workshop / battery dealer.
• Store the battery in a cool, dry and well ventilated place.
• Cover the silencer with plastic bags to prevent moisture entry. Set the motorcycle on its center stand.
• Apply anti rust solutions on all plated parts. Take care not to apply this solution on rubber or painted parts.
• Store motorcycle in a clean covered area free - of moisture and dust.
• For re-use after storage, it is preferable to get the motorcycle prepared through a Royal Enfield Authorised Dealer / Service Center to ensure the motorcycle is restored to its peak operating conditions.

Trouble Shooting

We have listed below a few basic checks in case your motorcycle is not functioning. If in case the problem is not rectified after these checks, it is necessary to get the motorcycle checked by a Royal Enfield Authorised Dealer / Service Center to rectify the problem and to ensure trouble free performance.

PERSONAL & MOTORCYCLE INFORMATION

 

See also: