Moto Guzzi V85 TT - Service manual > Back side

TABLE A - WIRING ON THE SEAT PILLAR

1. Medium sized cable ties

Once the lower seat pillar closing is mounted, remove the two clamps (1)

TABLE A1 - WIRING ON THE SEAT PILLAR

• Proceed as indicated in the figure

TABLE A2 - WIRING ON THE SEAT PILLAR

1. Engine control unit

Connect the engine ECU (1) and hook it to the specific plastic base

TABLE A3 - WIRING ON THE SEAT PILLAR

1. Secondary fuses

Fasten the secondary fuses box in the specific supports, taking care to run the wiring on the external side

TABLE A3 - WIRING ON THE SEAT PILLAR

1. Secondary fuses

Fasten the secondary fuses box in the specific supports, taking care to run the wiring on the external side

TABLE A5 - WIRING ON THE SEAT PILLAR

1. USB 2 power socket predisposition
2. Main fuses
3. Battery cover (mounted)

Fasten the USB2 power socket predisposition in the specific support and the main fuses as illustrated in the figure

TABLE B - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Licence plate holder

TABLE B1 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Taillight wiring harness
2. Grey reference for positioning

TABLE B2 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Fastening clip
2. Grey reference for positioning

TABLE B3 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Wire from wiring harness
2. Taillight wire

Connect the taillight and hook it to the support

TABLE B4 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Fastener clip
2. Licence plate light

Insert the licence plate light (2) in the specific lodging and connect the right indicator to the wiring harness. Arrange the cables as illustrated in the figure.

TABLE B5 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Fastener clip

TABLE B6 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Screws
2. Licence plate holder

Close the licence plate holder (2) with the specific cover, using the screws (1)

TABLE B7 - COMPLETE TAILLIGHT AND LICENCE PLATE HOLDER (PRE-ASSEMBLY)

1. Licence plate holder

Licence plate holder (1) complete and closed

TABLE C - REAR WHEEL SPEED SENSOR

1. Rear speed sensor
2. Speed sensor fastening
3. Cable gland

Run the wire inside the slot in the rubber cap

TABLE C1 - REAR WHEEL SPEED SENSOR

1. Clip
2. Cable gland

TABLE C2 - REAR WHEEL SPEED SENSOR

1. Small clamp
2. Speed sensor connector

Connection of the speed sensor is fastened with a clip

See also: