Ducati Scrambler 800 - Service manual > Stands

Refitting the side stand

Insert the side stand duly greased with specified product.

Fix with pin (10).

Tighten nut (9) to a torque of 20 Nm +- 10%.

Position springs (7) and (8) fixing them in retainers (A) and (B).

Place sensor (2) on the side stand inserting the sensor pin (C) into the stand hole (D) and aligning the stand pin (E) with the sensor opening (F).

Start and tighten the screw (6) with pre-applied threadlocker to a torque of 5 Nm +- 10%.

Place the side stand on the frame, fit screw (3) and tighten it to a torque of 36 Nm +- 10%.

Tighten the screw (4) to a torque of 36 Nm +- 10%.

Removing the side stand

Properly support the vehicle.

Disconnect connector (1) of the side stand switch (2) from the main wiring.

Undo screw (3) securing stand to engine block.

Undo the retaining screw (4) of the footpeg holder plate (5).

Remove the side stand.

Disassembling the side stand

Loosen screw (6) and remove the switch from the stand.

Release stand return springs (7) and (8) disengaging them from retainers (A) and (B).

Loosen nut (9) of pin (10) retaining stand to plate.

See also: