Ducati Scrambler 800 - Service manual > Removing the number plate holder
Note This procedure is valid for all customisations except the CLASSIC one.
To make the number plate holder removal easier, we recommend removing also the chain guard.
Remove screw (1) and the relevant bushing (2).
Remove screw (3).
Disconnect the connector (4).
Loosen screws (5) of cable rings (6).
Remove clamp (7).
Remove the two screws (8) that retain the number plate holder subframe support (9) to swinging arm (10).
Remove screws (11) and (12) that retain the number plate holder subframe to the swinging arm.
Remove the number plate holder subframe.
In the picture the chain guard has not been removed yet.
Disassembling the number plate holder
Remove screws (13) to release the number plate light wiring.
Remove the three screws (14) securing the number plate holder plate (15).
Remove the number plate holder from its support.
Remove the number plate light (17) by loosening the two screws (16).
See also:
Ducati Scrambler 800 - Service manual > Refitting the tail light
Position tail light (3) so that stud bolts (A) are in their seats (B) on the frame.
Ducati Scrambler 800 - Service manual > Electrical components compartment
Refitting the electric components compartment If previously removed, refit heat guard (4) on case (5) on the rear side with heat reflective material, as shown in the figure.
Ducati Scrambler
Fantic Caballero 500
Indian FTR 1200
Moto Guzzi V85 TT
Royal Enfield Bullet Trials Works Replica
Triumph Scrambler 1200 XE
Triumph Street Scrambler
Yamaha XSR700
Ducati Scrambler 800
Moto Guzzi V85 TT
Triumph Scrambler 1200 XC